Replacement 1 RPM auger motor for Breckwell and USSC pellet stoves. Fits the following models:
NOTES:
- This auger motor fits all Breckwell pellet stove models produced in 2003 and after, as well as some of the old P22 and P23 stoves. This auger motor has a clockwise rotation on the shaft, a mounting hole drilled in the shaft for a cotter pin, and wire leads. Not all stoves use the same connection type; if your unit needs different female/male spade clips, these can be removed and changed out. To best determine compatibility, please double-check the spacing on your auger shaft. The auger shaft coils will be spaced 1" apart to indicate setup for 4RPM, whereas 2" spacing indicates setup for 1 RPM.
- Serial numbers are approximate and should not be the only source of validation for the part. Serial numbers may be off by as much as 10 units either way.
Non-OEM replacement for Breckwell part # C-E-017 and C-E-017M
Breckwell Pellet Stoves:
- P22 Maverick - All Units
- P22I Maverick Insert - All Units
- P23 Sonora - Serial # 7166 to Present, and Units BEFORE serial # 6332
- P23I Sonora Insert - Serial # 2243 to Present, and Units BEFORE serial # 1916
- P24 Blazer - Serial # 53664 to Present
- P24I Blazer Insert - Serial # 53795 to Present
- P1000 Big E - All Units
- P2000 Tahoe - Serial # 11780 - Present
- P2000I Tahoe Insert - Serial # 22208 - Present
- P2700 Mojave - Serial # 8445 - Present
- P4000 Classic Cast - All Units
- SP1000 Big E
- SP1002 Big E II
US Stove Pellet Stoves:
- 5040 Pellet Heater
Aftermarket replacement for USSC part # 80642
OEM USSC part here
Aftermarket USSC part
May fit other models; please check your owner’s manual for part number compatibility.
This product has a 18-month manufacturer’s warranty. The warranty is void if the part is installed in a unit it is not compatible with.